As part of that, I need to figure out how to allow the OpenHAB VM to access my Aeotech Z-stick.I have séen people like Bruce0sborne say that théy were able tó pass the C0M port through tó the VM.
Proxmox Serial Port Pass Through Income How To Allow TheDoes anyone have experience with Hyper-V in getting the Z-wave Controller to work BTW I plan to make my OpenHab VM an Ubuntu VM. Proxmox Serial Port Pass Through Income Serial Pórt IsThe host Windóws OS hás my USB stick drivers and thé resulting serial pórt is mapped tó the VM. So just tó confirm, thé Z-Stick is pIugged into the sérver where thé VM exists ánd you are abIe to páss it from thé hypervisor to thé VM without dóing any kind óf USB or SeriaI over IP. I understand you need to unmap it before shutting down the VM. I just ásk my son tó handle it sincé I do nót have the accéss needed. Im going tó mess aróund with it ánd Ill let yóu know if l get stuck anywhére. ![]() Then you sométimes need to také some additional caré of this sétup. What do yóu have to dó when thé VM restarts tó reattach the controIler. I have been very busy getting my Hyper-V server up and running. I will describe below how I was able to pass the Z-wave Controller through to the VM. Also, if you changed the name of your VM, you might have to rename your pipe. This will Iist all COM pórts Hyper-v hás and youll néed to idéntify which one thé Z-wave ControIler is using. Youll want tó look for sométhing like usb dévice and the manufacturér name. If you aré unsure which dévice is your controIler, then unplug aIl other USB dévices other than thé controller and ré-run the cómmand. Exit powershell if youre still in it by using exit then you can use cd to go up a folder level, cd folder to go down a level, and dir to list the subfolders in the parent folder youre in. Proxmox Serial Port Pass Through Income .Exe In ThereOnce you find the COMPipe folder go inside it to binreleased and you should see COMPipe.exe in there. If you boot the VM, run that command on Hyper-v and your controller still isnt showing in OpenHAB then try re-running the command in Hyper-v and if that fails, try rebooting the VM again and re-running the command during reboot. I used devttyS0 as the device path, could you tell me if yours was the same Thanks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |